Samsung WA5471 Series - Page 7

ALIGNMENT AND ADJUSTMENTS
7
Service Mode
Service Mode:
1.ThewashermustbeontogointotheServiceMode.
2.Themotorspeedwillbedisplayedwhenstarted(Itdisplays0whenthemotordoesnotspin).
3.Thepresentstateofthemachinewillnotbechanged.
(i.e.,thecurrentcycleinprogresswillnotbeinterruptedandonlythedisplaywillchange)
4. ToexitServiceMode,pressSignalandExtraRinseKeysfor3secondagain,orPowerKey.Ifnokey
isoperatedduringServiceModefor5minutes,themachinewillreturntonormalusermode.
Quick Spin Test Mode
Denition of Quick Spin Test Mode:
- QuickSpinTestModeistodoSpinCheck.(HighRPM)
How to Enter:
- DuringServiceMode,presstheDelayStartandTemp.Keysfor3secondstoenterQuickSpin
TestMode.
- Cannotenteroncethewashingcyclehasstarted.
Quick Spin Test Mode:
AsitentersintotheQuickSpinTestMode,itstartsspinningandreachestoitsmaximumRPM.
OncetheSpinspeedreachesthemaximumRPM,thespeeddropsimmediately.
ToholdQuickSpinTestMode(enteringHoldSpeedMode),presstheStart/Pausebutton.Ifthe
Start/PausebuttonispressedduringQuickSpinTestMode,itwillstopacceleratingandholdits
spinningspeedfor10minutesbeforegoingbacktoQuickSpinTestMode.
Also,tocanceltheholdandallowQuickSpinTestModetocontinue,presstheDelayStartand
TempKeystogetherfor3seconds.
IfyouholddowntheDelayStartandTemp.keysforthree(3)secondswhenthewashingmachine
isnotinHoldSpeedMode,QuickSpinModeisexitedandServiceModeisrestored.
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
WA5471ABP_03051A-01(Technical information).indd 7 2011-05-30 �� 2:38:34