Samsung WD10 K6 /X Series - Page 24

22 _Disassembly and Reassembly
Partname Description Figure
BUBBLEPUMPAND
DRAINPUMP
6.Releaseallbandringtoremovalhose
exceptforhosedrain.
7.Pushthepumpinwardsslightlyand
remove it.
8.Releasetheclamperhosewhichcon-
nectedpumpandhosedrain,then
separate it.
★
CheckPointsforTroubleshooting
1.SeparatetheDrainFilterandcheckifanyaliensubstancesarein-
sidethepump(e.g.coins,buttons..,etc.)→Removetheseiffound.
2.Checkifthewiredrivingthepumphascomeloose→Taketherel-
evant countermeasure if necessary.
3.Whenwaterleaks,checktheassemblystatusoftheClampHose,
andCapDrain→Taketherelevantcountermeasureifnecessary.
Turntheltercounterclockwisetoremovetheremainingwater.
HOSE-TUB
1.SeparatetheBANDRING,
andthenremovetheHOSE
hose-tub.
WD6500K_7-8-9-11kg_1400rpm-SM.indb 22 2018/11/9 9:53:09