Samsung WD8704EJZ - Connecting the Water and Drain; Adjusting the Levelling Feet

setting up your new washing machine _17
01 setting up
STEP 3

Wheninstallingyourwashingmachine,ensurethatthepowerplug,thewatersupplyand
the drain are easily accessible.
1. Slide the washing machine into position.
2. Levelyourwashing
machine by turning the
leveling feet in and out as
necessary by hand.
3. Whenyourwashingmachineislevel,tightenthenutsusing
the wrench supplied with your washing machine.
STEP 4

Connecting the water supply hose
1. TaketheL-shapedarmttingforthecoldwater
supply hose and connect it to the cold water
supply intake on the back of the machine.
Tighten by hand.
The water supply hose must be connected
to the washing machine at one end and to
thewatertapattheother.Donotstretchthe
watersupplyhose.Ifthehoseistooshort,
replacethehosewithalonger,highpressure
hose.
2. Connecttheotherendofthecoldwatersupply
hosetoyoursink’scoldwatertapandtighten
itbyhand.Ifnecessary,youcanrepositionthe
water supply hose at the washing machine end
bylooseningthetting,rotatingthehose,and
retighteningthetting.

1. TaketheredL-shapedarmttingforthehotwatersupplyhoseandconnectittothehot
water supply intake on the back of the machine. Tighten by hand.
2. Connecttheotherendofthehotwatersupplyhosetoyoursink’shotwatertapandtighten
it by hand.
3. UseaY-pieceifyouonlywanttousecoldwater.
WD8704RJ-02718A-07_EN.indd 17 2014/6/11 17:14:00