Samsung WD8704EJZ - Page 18

18_ setting up your new washing machine
Connecting the water supply hose (selected models)
1. Remove the adaptor from the water supply hose.
2. First,usinga‘+’typescrewdriver,loosenthefourscrews
ontheadaptor.Next,taketheadaptorandturnpart(2)
followingthearrowuntilthereisa5mmgap.
3. Connecttheadaptortothewatertapbytighteningthe
screwsrmlywhileliftingtheadaptorupwards.
Turnpart(2)followingthearrowandconnect(1)and(2).
4. Connectthewatersupplyhosetotheadaptor.
Whenyoureleasepart(3),thehoseautomatically
connectstotheadaptormakinga‘click’sound.
After you have connected the water supply
hosetotheadaptor,ensurethatitisconnected
correctly by pulling the water supply hose
downwards.
5. Connecttheotherendofthewatersupplyhosetotheinlet
water valve at the rear of the washing machine. Screw the
hose clockwise all the way in.
setting up your washing
machine



1
2

3
1
2

WD8704RJ-02718A-07_EN.indd 18 2014/6/11 17:14:01