4
■ How to Level the Unit
1. Select an installation place.
▶Install the unit with 10cm or more
clearance from its surrounding walls.
▶The unit is also available for
alcove or closet installation.
2. Check if the unit is leveled.
▶If the unit wabbles, adjust the leveling
legs.
3. Adjust the leveling legs.
▶ The 4 leveling legs
should touch the floor
all together.
※ Caution ※
Tighten the lock nut after
the leveling. If not, it
could generate vibrations &
noises.
When the unit is not leveled
▶Lift up the unit a little bit and adjust the shortest.
▶Turn the leveling bolt counter clockwise as shown in the picture above
(The leveling leg gets longer.)
▶ After adjusting the leveling
bolt, tighten the lock nut by
turning it clockwise.
Lock Nut
Leveling Bolt
Spanner
Flat Head
Screwdriver
To Next Page
Loading...
