28_ cleaning and maintaining your washer
PURE CYCLE
TM
(WF221*)
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Pure Cycle
TM
button.
• You can only use the Delay Start
function.
3. Press the Start/Pause button.
• If you press the Start/Pause
button, Pure Cycle begins.
• The required time for the Pure Cycle is determined by the temperature of the supplied water.
In general, if hot water is supplied, the Pure Cycle will take approximately 2 hours.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing machine. This may cause damage to
the laundry or a problem with the washing machine.
• If you want to use drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Alarm Function
• If the “Pure Cycle” button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Pure Cycle.
• If you do not run Pure Cycle, the “Pure Cycle” indicator
turns off. However, the “Pure Cycle” indicator will light
again after two washes. Not running Pure Cycle at this
point will not cause a problem with the washing machine.
• Although generally, the Pure Cycle Auto Alarm appears
once a month or so, the frequency may differ depending
on the number of times the washing machine is used
cleaning and maintaining your
washer
CAUTION
WF221ANS-02832F_EN_v5_re.indd Sec7:28WF221ANS-02832F_EN_v5_re.indd Sec7:28 2011-07-15 3:17:262011-07-15 3:17:26
To Next Page
Loading...
