32_ troubleshooting and information codes
A fault is detected in the water
level sensor.
Call for service
Jammed Key. Call for service
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it finishes washing, End and
Sd codes will blink in turn.
To prevent, reduce the amount of detergent.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting and
information codes
WF221ANS-02832F_EN_v5_re.indd Sec4:32WF221ANS-02832F_EN_v5_re.indd Sec4:32 2011-07-15 3:17:272011-07-15 3:17:27
To Next Page
Loading...
