Problem What To Do
Noisy and/or Vibration/Walking
• Check if the washer is leveled and the lock nuts are tightened up on the bottom
plate.
• Check if all of the shipping bolts and spacers are removed from the back panel.
• Check if load is big enough and there is no unbalance. If there is not enough
load, put in a few towels to balance it.
• Check if the motor is fastened enough.
• Remove various trouble contributors (such as dust coat on the floor).
Rubber Feet Leaving Marks
on Floor
• Use a pencil eraser to remove mark.
• Walk washer into location, do not drag.
Additive Cups Full of Water
• Small amount of water in bottom of additive cups is normal.
• Remove and wash Dispenser Tray, removable Cup, and Rinse Cap.
• Level washer.
Buttons do not Respond
• Option and Function buttons respond differently according to each cycle.
• Child Lock feature has been selected. To disable feature press and hold Temp
and Spin simultaneously until a beep is heard.
• When display shows “End”, only the Power button will function. Press Power
and make new cycle selections.
5.SVC Information ( Troubleshooting)
50
To Next Page
Loading...
