Samsung WF457ARGSGR/AA - Page 10

ALIGNMENT AND ADJUSTMENTS
10
Cycle Count Check Mode
Denition of Cycle Count Check Mode:
- CycleCountCheckModeistotallyupthenumberofwashings.
How to Enter:
Model : WF455AR*
- ToentertheCycleCountCheckMode,presstheSignalKeyduringServiceMode.
Model : WF457AR*
- Press“2”onTheServiceMode.
Cycle Count Check Mode:
1. ActivatetheServiceModeinadvance.
2.WhentheSignalkeyispressed,thetotalnumberofwashingswilllightupandasignalLCD/
LEDwillglow.
3.Themaximumnumberofcycleswillbe9999.
Thecounterwillrolloverto0andstartcountingagainafter9999.
4.Thecountingwillbecarriedoutattheendofthenormalcycle.
(FornormalandContinuousRuncycles,thecountiscarriedoutattheendofthecycles.
5. ToexittheCycleCountCheckMode,pressthe“Signal”keyagain.
S/W Version Check Mode
Denition of S/W Version Check Mode:
- S/WVersionCheckModeistobringupS/WVersioninformation.
How to Enter:
Model : WF455AR*
- ToentertheS/WVersionCheckMode,presstheSoilLevelKeyduringServiceMode.
Model : WF457AR*
- Press“4”OntheServiceMode.
S/W Version Check Mode:
1. ActivatetheServiceModeinadvance.
2. PresstheSoilLevelKeytobringupitssoftwareVersion
EX)GeneratedE49atVersion49(dEisMicomcode,49isit’ssoftwareversion)
3. ToexittheS/WVersionCheckMode,presstheSoilLevelS/Wonceagain.
Then,itreturnstotheServiceModewithmotorRPMilluminating.
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
WF455AR* : Signal
WF457AR* : 2 Key
Service Mode Cycle Count
WF455AR* : Soil Level
WF457AR* : 4 Key
Service Mode
S/W Version Check
Mode
(Techsheet)WF457AR-03152A_EN.indd 10 2012-03-07 �� 3:25:51