EasyManua.ls Logo

Samsung WF45H6300AW/A2 - 4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE

Samsung WF45H6300AW/A2
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 _ Troubleshooting
4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE
► Thesearecommontroubleshootingproceduresforeachdrum-typewashererrormode.Fordetailedinformation,refertothegeneralrepairscripts.
Error Type Error Mode Causes Corrective Actions Description of Photo
WaterLevel
Sensor
1E
• Waterlevelsensorfault
• Incorrectconnectionsof
thewaterlevelsensor
terminal
• Thehosepartforthe
waterlevelsensoris
folded.
• MainPCBfault
• Checkthewaterlevelsensorterminal
connectionsandcontacts.
• Anerroroccursifanincorrectwaterlevel
sensorisused.Makesuretocheckthe
materialcode.(Abnormaloperation)
• Ifthewaterlevelsensorisfaulty,replaceit.
• Iftheerrorpersistsdespitetakingtheaction
above,replacethePBA.
Checkthewaterlevelsensor
frequency.
- Checkitafterthewaterlevelsensor
andtheconnectorareconnected.
CheckingPart:
PinkColorWireOrangeColorWire.
-Frequency:
Approx.25.5KHzwithnoload
WashingMotor
ErrorandHall
Sensor Error
3E
• Washingmotorfault
• Washingmotorhall
sensorfault
• Incorrectconnectionsof
thewashingmotor/hall
sensor connector
• Washingmotorrotorand
statorfault
• MainPCBfault
• Checkthemotorconnectorterminal
connectionsandcontacts.
• 3Eisdisplayedbecauseoverloadingoccurs
duetotoomuchlaundry.
• Ifthehallsensorterminalisfaulty,replace
thehallsensor.
• Checkwhetherthestatorofthemotorcover
isdamaged.
• Checkforcoildisconnectionsduetoforeign
material.
• IfthePBAcontrolcircuitisfaulty,replacethe
PBA.
► CheckthemotorWindingCoil
Plugouttheconnectorandread
resistancesatanytwoofthethree
terminalsonMotor
:Shouldbe6.0Ω(at25°C)
► CheckthemotorHallSensor
ChecktheresistanceonthemainPCB
motor
(Betweenpins1and3,and1and4of
thefour(4)pins)
- Resistance
:Approx.2to4MΩ
- Checkthevoltagewhenthepower
is on.

Related product manuals