Installation
English 27
Wall standpipe drain system
The drain hose must be placed into a wall
standpipe drain system. To keep the end of
the drain hose bent, use the supplied hose
guide (A). Secure the guide to the wall
using a hook to ensure stable drainage.
STEP 6 Remove the lm inside the door
Remove the small circle lm (B) above the
door latch before use.
STEP 7 Power on
Plug the power cord into an AC 120 V / 60 Hz approved electrical outlet protected by a
fuse or circuit breaker. Then, press POWER to turn on the washer.
WF5500M-03773A-01_EN.indd 27 2017-01-10 11:46:18
To Next Page
Loading...
