Samsung WF45T6200A Series - Page 25

English 25
Installation
*
A
(*): Min. 6 in. (152 mm), Max. 8 in.
(203 mm)
3. Route the drain hose to the drain
system.
CAUTION
• If using a standpipe, make sure the
standpipe and drain hose connection is
not airtight.
• If using a standpipe, make sure the
drain hose is inserted at least 6 in.
(152 mm) but no more than 8 in.
(203 mm) into the standpipe.
4. Secure the drain hose with cable ties.
AA
Over the edge of a wash basin
The drain hose must be placed no lower
than 24 in. (60 cm) and no higher than
35 in. (90 cm) from the oor. To keep
the spout of the drain hose bent, use the
supplied plastic hose guide (A). Secure the
guide to the wall using a hook to ensure
stable drainage.
STEP 6 Remove the lm inside the door
B
Remove the small circle of lm (B) above
the door latch before use.
STEP 7 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet
protected by a fuse or circuit breaker. Then, press Power to turn on the washer.
Untitled-2 25 2019-11-15  12:09:26