protection of cable from Water
If this product is mounted outdoor, water leakage may occur at gap between cables. As shown below, butyl rubber (available on the
market) shall be used to protect from water.
1. Connect power supply and BNC power source.
2. Cover black sheath of the cable (Zone A), and ensure half of butyl rubber can cover the cable joint.
J
`
Poor water protection at the cable sheath may cause water leakage. Make sure to wrap tightly.
`
The water-proof butyl rubber is made of rubber that expands to twice the original length.
`
If you do not use cable joint, it must be covered with water-proof tape.
connecting the nVr
Use a 12V 0.5A power adpator to power each wireless camera. There is no need to connect cameras to NVR as it is wireless AIO.
HDMI
VGA
12V
CAUTION
RISK OF ELECTR
I
S
HOCK
DO NO
T OPE
N
CAUTION : TO REDUCE TH
E RISK
OF ELECTRICAL SHOCK
DO NO
T OPEN
COVER
S. NO USER SER
VICEABLE
PARTS
INS
IDE. REFER
SERVI
CING TO
QUALIFIED
SER
VICE
PERSO
NNEL.
WARNIN
G : TO PRE
VE
NT FIRE OR SHOC
K HAZARD. DO
NOT
EXPOSE UNITS
NOT S
PECIFICALLY DESIGNED
FOR OUTDOOR USE TO RA
IN OR MOISTURE.
WAN
English _5
To Next Page
Loading...
