13 _ Disassembly and Reassembly
This Document can not be used without Samsung’s authorization.
Part Figure Description
Assy Panel Control
(Simple)
4. Connect the terminal by hand. Take a look at
the hook and put it in the right place.
Be careful not to break the hook.
Make sure the Wire harness are not getting
stuck in other parts.
5. Attach the Assy Cover Panel to the front and
slide about 10mm to the right.
6. Fit the cover screw to the red braille mark, x
the top to the hook, and x one screw to the
panel control using a (+) driver.
To Next Page
Loading...
