English
Installation
English22
3. Hold the adaptor and turn part (C) in the arrow
direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and then
tighten the screws while lifting the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
6. While pulling down part (D) on the water hose,
connect the water hose to the adaptor. Then, release
part (D). The hose fits into the adaptor with a clicking
sound.
7. To complete connecting the water hose, see 2 and 3
on the “Connecting to a threaded water tap” section.
NOTE
• After connecting the water hose to the adaptor, pull the water hose down to check if it is connected
properly.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the spacer ring before
inserting the tap into the adaptor.
Untitled-1 22 2022-10-05 12:14:41
To Next Page
Loading...
