What to do if Samsung WW80T534ATW/S2 Washer door does not open?
If the door of your Samsung washer won't open, tap and hold the start button to stop the machine. It may take a few moments for the door lock to disengage. The door will not open until 3 minutes after the washer has stopped or the power has been off. Ensure all water in the drum is drained and that the door lock light is off.
Why Samsung Washer water supply is insufficient, or no water is supplied?
If your Samsung washer isn't getting enough water, fully open the water tap and ensure the door is properly closed. Check that the water supply hose isn't frozen, kinked, or clogged, and that there is sufficient water pressure. Make sure the cold and hot water taps are properly connected. You may also need to clean the mesh filter, as it could be clogged.
Why Samsung WW80T534ATW/S2 stops?
If your Samsung washer stops mid-cycle, ensure the power cord is plugged into a live electrical outlet and check the fuse or reset the circuit breaker. Close the door and tap and hold the start button. There may be a pause or soak period in the cycle, so wait briefly. Make sure the mesh filter of the water supply hose is not clogged. Insufficient power can also cause the washer to stop temporarily.
Why Samsung WW80T534ATW/S2 excessive suds?
Excessive suds in your Samsung washer can be due to using the wrong type of detergent. Use the recommended types of detergent as appropriate, and opt for high efficiency (HE) detergent to prevent oversudsing. Reduce the detergent amount for soft water, small loads, or lightly soiled loads. Non-HE detergent is not recommended.
How to fix a Samsung Washer that does not start?
If your Samsung Washer doesn't start, ensure it's properly plugged in, the door is fully closed, and the water taps are open. Press and hold the start button. Also, verify that Child Lock is deactivated and that no laundry is caught in the door. It's normal for the washer to make clicking noises and do a quick drain before filling. Check the fuse or circuit breaker and ensure proper power supply. For 'AddWash door is open' message, close the AddWash door properly and press and hold the start button.
Why does my Samsung WW80T534ATW/S2 show an unbalance error?
The unbalance error on your Samsung Washer is caused by the laundry load. Check the laundry to resolve this issue, as this occurs by laundry.
What to do if Samsung WW80T534ATW/S2 not filling with water?
If your Samsung Washer isn't filling with water, consider these possible solutions: * Fully open the water tap. * Ensure the door is properly closed. * Check that the water supply hose isn't frozen, kinked, or clogged. * Verify sufficient water pressure. * Make sure the cold and hot water taps are correctly connected. * Clean the mesh filter, as it may be clogged.
What to do if my Samsung WW80T534ATW/S2 does not drain or spin?
If your Samsung Washer isn't draining or spinning, ensure the drain hose is fully straightened to the drain system. Check that the debris filter isn't clogged and clean it if necessary. The door must be closed for the washer to tumble or spin. Also, verify that the drain hose isn't frozen or clogged, and that it's properly connected to a drain system that isn't clogged. Insufficient power supply can also temporarily prevent draining or spinning; the washer will resume normal operation once sufficient power is restored.
How to fix a Samsung WW80T534ATW/S2 that won't start?
If your Samsung Washer doesn't start, check the following: Ensure the washer is plugged in, the door is properly closed, and the water taps are open. Tap to start the washer. Make sure Child Lock is not activated. Check the fuse or reset the circuit breaker, and verify that power is supplied properly. If there is low voltage, check the power cord. Ensure no laundry is caught in the door. If the 'AddWash door is open' message appears, close the AddWash door properly and tap to try again, or open the AddWash door, add laundry, close it completely, and tap to resume.
Why is my Samsung WW80T534ATW/S2 leaking water?
If your Samsung Washer is leaking water, make sure the door is properly closed and all hose connections are tight. Ensure the drain hose is correctly inserted and secured to the drain system. Avoid overloading the washer and use high-efficiency (HE) detergent to prevent excessive suds. Check the drain hose to ensure it's not placed on the floor or clogged.
To Next Page
General