English
Installation
English22
Connecting to a non-threaded water tap
1. Remove the adaptor (A) from the water hose (B).
2. Use a Phillips screwdriver to loosen four screws on
the adaptor.
3. Hold the adaptor and turn part (C) in the arrow
direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and then
tighten the screws while lifting the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
U-PJT_WASHER-MD_SimpleUX_DC68-04220A-01_AU_EN(����+�7.5��).indd 22 2020/9/29 13:02:31
To Next Page
Loading...
