2 _ Safety Instructions
WARNING
WHILE SERVICING
• Check if the power plug and outlet are damaged, attened, cut or otherwise degraded.
4 If faulty, replace it immediately.
Failing to do so may result in electric shock or re.
• Completely remove any dust or foreign material from the housing, wiring and connection parts.
4 This will prevent a risk of re due to tracking and shorts in advance.
• When connecting wires, make sure to connect them using the relevant connectors and check that they are properly connected.
4 Do not use tape instead of the connectors, it may cause re due to tracking.
• Make sure to discharge the PBA power terminals before starting the service.
4 Failing to do so may result in a high voltage electric shock.
• When replacing the heater, make sure to fasten the nut after ensuring that it is inserted into the bracket-heater.
4 If not inserted into the bracket-heater, it touches the drum and causes noise and electric leakage.
• Do not repair the washing machine without safety gloves.
4 It can cause injury.
WARNING
AFTER SERVICING
• Check the wiring.
4 Ensure that the wiring can not be damaged by any sharp edges or moving parts.
• Check for any water leakage.
4 Perform a test run for the washing machine using the standard course and check whether there is any water leakage
through the oor section or the pipes.
• Advise consumers not to repair or service any part of the washing machine themselves.
4 This may result in personal injury and shorten the product lifetime.
To Next Page
Loading...
