24 English
Installation
Installation
CAUTION
Do not stretch the water hose by force. If the hose is too short, replace the hose with a longer, high-
pressure hose.
Connecting to a non-threaded water tap
1. Remove the adaptor (A) from the water hose
(B).
2. Use a Phillips screwdriver to loosen four
screws on the adaptor.
3. Hold the adaptor and turn part (C) in the
arrow direction to loosen it by 5 mm (*).
4. Insert the adaptor onto the water tap, and
then tighten the screws while lifting the
adaptor.
5. Turn part (C) in the arrow direction to tighten
it.
WW3000TM_FA_8C104-000708_EN.indd 24WW3000TM_FA_8C104-000708_EN.indd 24 2021-04-07 4:05:322021-04-07 4:05:32
To Next Page
Loading...
