English 25
Installation
6. While pulling down part (D) on the water
hose, connect the water hose to the adaptor.
Then, release part (D). The hose fits into the
adaptor with a clicking sound.
7. To complete connecting the water hose, see 2
and 3 on the “Connecting to a threaded water
tap” section.
NOTE
• After connecting the water hose to the adaptor, check if it is connected properly by pulling the water
hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the spacer ring before
inserting the tap into the adaptor.
WW3000TM_FA_8C104-000708_EN.indd 25WW3000TM_FA_8C104-000708_EN.indd 25 2021-04-07 4:05:332021-04-07 4:05:33
To Next Page
Loading...
