Samsung WW90M6 - Page 27

Disassembly and Reassembly _ 25
Part Figure Description
Heater
4. Removethenutholdingtheheaterand
separatetheHeater.
 UseboxDrivers(Socketsize:10mm)
5. RemovetheHeaterfromtheTub
Caution
MakesuretoinserttheHeaterintothe
correctpositionofthebracketinsidethe
Tubwhenreassemblingit.Otherwise,there
isadangerofare.
 Makesuretopushitinwardsuntilthe
packingpartcomesintotheTubcompletely
whenreassemblingitsothatthepacking
partiscompletelystucktotheTub.Fasten
theholdingnutwithaforceof5Kgf/cm2.
Ifthenutisnotfastenedproperly,thereisa
dangerofwaterleaking.
WW22N6850NX-A2_SM.indb 25 2018/2/1 17:15:45