18
CYLINDER PROTECTION INSERTS
The machine has four cylinder protection inserts between the lowest dies in the crimping head.
These inserts protect the cylinder from dirt and falling parts.
NOTE! Protection inserts have to be
interposed always between the lowest dies.
Because the master dies try to rotate during
the operation, the inserts have to be moved
into correct places every now and then.
Replace the inserts if they lose their
resilience or if they don’t stay still in their
places or if they don’t fill in their space
properly.
Purchase numbers:
20 model: 702933
32 model: 702932
OIL CHANGE
Change hydraulic oil after the first 500 hours of operation and every 1000 hours or once a year thereafter.
Oil tank volume: 27 litres.
Recommended oil: Shell Tellus T46 or equivalent.
Empty the tank of oil through the draining plug behind the tank.
Handle the waste oil according to law.
Fill the tank to centre line of the indicators in the dipstick of the filling cap.
It is recommended to pump the oil into the tank through a 20 filter, because new oil in drums is not
pure.
If any oil has run out on the floor, wipe it away.
FILTER CHANGE
Filter insert must be changed
together with oil.
Open the filter cover,unscrew the
filter insert and remove it.
Handle the old filter according to the law.
Lubricate the seal of the new filter
insert with hydraulic oil.
Install the filter cover.
Screw the filter insert on.
Purchase number: 710424.
To Next Page
Loading...