Introduction
S&C Instruction Sheet 1045-530 3
Replacement parts provided by the seller or repairs performed by the seller under
the warranty for the original equipment will be covered by the above special warranty
provision for its duration. Replacement parts purchased separately will be covered
by the above special warranty provision.
For equipment/services packages, the seller warrants for a period of one year after
commissioning that the 6800 Series Automatic Switch Control will provide automatic
fault isolation and system reconfiguration per agreed-upon service levels. The remedy
shall be additional system analysis and reconfiguration of the IntelliTeam SG Automatic
Restoration System until the desired result is achieved.
Warranty of the S&C 6800 Series Automatic Switch Control is contingent upon
the installation, configuration, and use of the control or software in accordance with
S&C’s applicable instruction sheets.
This warranty does not apply to major components not of S&C manufacture, such
as batteries and communication devices. However, S&C will assign to the immedi-
ate purchaser or end user all manufacturer’s warranties that apply to such major
components.
Warranty of equipment/services packages is contingent upon receipt of adequate
information on the user’s distribution system, sufficiently detailed to prepare a tech-
nical analysis. The seller is not liable if an act of nature or parties beyond S&C’s con-
trol negatively impact performance of equipment/services packages; for example,
new construction that impedes radio communication, or changes to the distribution
system that impact protection systems, available fault currents, or system-loading
characteristics.
To Next Page
Loading...
Need help?
General
