S&C Instruction Sheet 761-505 3
Introduction
Warranty
Warranty
Qualifications
The warranty and/or obligations described in S&C’s Price Sheet 150 “Standard Conditions
of Sale – Immediate Purchasers in the United States” (or Price Sheet 153, Standard
Conditions of Sale – Immediate Purchasers Outside the United States) plus any special
warranty provisions, as set forth in the applicable product-line speci cation bulletin,
are exclusive. The remedies provided in the former for breach of these warranties shall
constitute the immediate purchaser’s or end user’s exclusive remedy and a ful llment of
the seller’s entire liability. In no event shall the seller’s liability to the immediate purchaser
or end user exceed the price of the speci c product that gives rise to the immediate
purchaser’s or end user’s claim. All other warranties, whether express or implied or
arising by operation of law, course of dealing, usage of trade or otherwise, are excluded.
The only warranties are those stated in Price Sheet 150 (or Price Sheet 153), and THERE
ARE NO EXPRESS OR IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. ANY EXPRESS WARRANTY OR OTHER OBLIGATION
PROVIDED IN PRICE SHEET 150 (OR PRICE SHEET 153) IS GRANTED ONLY TO THE
IMMEDIATE PURCHASER AND END USER, AS DEFINED THEREIN. OTHER THAN AN
END USER, NO REMOTE PURCHASER MAY RELY ON ANY AFFIRMATION OF FACT OR
PROMISE THAT RELATES TO THE GOODS DESCRIBED HEREIN, ANY DESCRIPTION
THAT RELATES TO THE GOODS, OR ANY REMEDIAL PROMISE INCLUDED IN PRICE
SHEET 150 (or PRICE SHEET 153.)
The standard warranty is applicable to the S&C Alduti-Rupter Switch detailed in this
instruction sheet except when it is power operated using a switch operator of other than
S&C manufacture.
Figure 1. Switch nameplates with ratings.
Nameplate on operating handle
Nameplate on switch base
In most applications, Alduti-Rupter Switches are capable of switching rated continuous
load currents at full voltage. The ratings for the particular switch are listed on nameplates
attached to the operating handle and the switch. See Figure 1.
These interrupter switches are not intended for breaking fault currents.
To Next Page
Loading...
Need help?
General
