S&C CS-1A User Manual

S&C Instruction Sheet 719-500 13
Installation
STEP 4� To return the manual operating handle to its
Storage position, pull the latch knob and pivot
the handle approximately 90 degrees. The handle
will then be disengaged from the switch operator
and may be rotated freely in either direction to its
Storage position. Complete the handle storage
by pivoting the operating handle backward
approximately 90 degrees until it latches in the
Storage position.
Note: The manual operating handle may be disengaged
from the switch operator mechanism at any position of the
handle. However, if the switch operator and circuit-switcher
are anywhere between the fully Open and fully Closed
position when the manual operating handle is placed in
the Storage position and the motor circuit fuseholder is
inserted, the switch operator will automatically move to
the Open position (because the switch operator control
circuit is designed to allow an electrical closing only from
the circuit-switcher's fully Open position).
Note: The handle may be padlocked in its Storage position.

S&C CS-1A Specifications

General

Brand	S&C
Model	CS-1A
Category	Switch
Language	English