26
Installing the Batteries (Remote Control)
1. Remove the cover on the back of the remote control
by sliding the battery compartment cover o.
2. Insert 2 x AAA batteries, ensuring that their
polarities (+ / –) are pointing in the right direction.
3. Slide the cover back into place. It will click when
securely tted.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause re,
personal injury or damage to property.
• Only use the battery type indicated in this manual.
• When the batteries are exhausted, the remote control will not function. Replace both batteries at the
same time with new ones.
• Do not install new batteries with used ones and do not mix dierent types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with local regulations.
Handling the Remote Control
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as it could cause
corrosion or battery leakage and may result in physical injury and/or property damage including re.
Switching the Unit On/Off
• Press on the unit or ON/OFF on the remote control. The Power Indicator will light up red,
indicating the unit is switched on (or in standby mode).
• To completely switch o the unit, press
on the unit or ON/OFF on the remote control.
Unplug from the mains supply.
SAC07C15E_IB_5L_150126_grace.indd 26 26/1/15 5:22 pm