5. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water inlet hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from
the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
• Connect one end of the water supply hose
to your dishwasher, and then connect the
other end of the hose to your water mains.
Please ensure the black rubber seals, one
in each end, are in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket, which must remain accessible to
allow disconnection of the appliance from
the mains supply.
• Do not bend your drain hose.
• Ensure your hose is not kinked or
squashed.
You may use a Y-adaptor (not included)
for additional water feed for another
appliance, for instance a washing machine.
This is only applicable for cold water mains.
A Y-adaptor is available from most DIY
stores.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
water supply hose
* images are for indication only; please refer to your individual model for actual details.
SDW60B12_IB_120522_Funnel Image_Pauline.indd 8 12年5月22日 下午10:36
To Next Page
Loading...
Need help?
General
