Quick Setup Guide
Connect the Sangean Internet Radio (WFR-20) either to wired or wireless LAN as shown below. This is the same
way as your PC is connected..
* No PC is needed. PC needs to be turned on and connected to the router only when you would like to play music
loaded in your PC (Media Shares or UPnP).
1. Turn on the router and the internet radio.
2. Connect the devices as the figure above.
3. It will display the main menu, and you can start to
operate it. Please read the instruction manual.
* If the wired connection is not working, after a few
seconds the display will change to show ‘Scan for
networks’
1. Turn on the router/ access point and apply power to
the internet radio.
2. Connect the devices as the figure above.
3. Press the SELECT control (a knob) on the radio, it
will scan for networks and will display all the
detectable network names.
4. Rotate and press the SELECT control to select your
network.. It can be your network model name or a
name you have given your network.
5. If there is a password for the encryption, input and
enter the password using the SELECT control. After
the correct password is entered the radio will connect
to the internet. Please read the instruction manual for
all the functions.
* After setting up as above, the internet radio is connected to internet and ready to be operated. Rotate and press the
turning knob on the internet radio to operate the functions.
PROBLEMS:
CALL TOLL FREE 1-888-SANGEAN (726-4326)
To Next Page
Need help?
General
