Need help?Do you have a question about the SANLI Bumble Bee Jnr BBJ300 and is the answer not in the manual?
General| Brand | SANLI |
|---|---|
| Model | Bumble Bee Jnr BBJ300 |
| Category | Lawn Mower |
| Language | English |
Attach lower handle bar bolts. Take the weight off the handle bar and fit the lower bolt first.
Pull the starter cord up to the spring and hold the cord at the lower side of the spring. Rotate the string clockwise around the spring.
Fit the right side Handle Knobs and Bolts. Place cable above lower loop handle during assembly.
Push the cable Clip into place.
Lift the Rear Flap with one hand and lower the Grass Catcher hook onto the bar.
Machine is now assembled.
Add 400ml of SAE 30 oil to the engine before the first use. Check oil level before each use.
Fill with min 95 octane premium unleaded petrol. Do not use Ethanol petrol (E10).
Ensure mower is on a flat area, push primer three times, move throttle to 'Run', pull starter cord firmly.
Attach catcher by lifting Rear Flap. Mow, then ensure engine is off before emptying.
Adjust cutting height centrally to suit mowing conditions. Do not remove too much grass at once.
Clean mower regularly. Store in a dry, well-ventilated area. Disconnect spark plug cap.
Ensure fuel tank is empty for transport. Cut lawn in alternating directions for best results.
Inspect mower for loose parts. Ensure good working order. Be sure of footing and keep body parts away.
Clear area of debris. Mow safely away from people/animals. Do not operate indoors or in poor light.
Never open fuel cap on a hot engine. Use fresh petrol. Do not smoke when fueling or operating.
Avoid mowing on slopes. Do not pull mower towards you. Wear safety gear like ear protection.
Inspect underside by tilting mower correctly. All warranty work by Authorised Dealer.
Summary of required maintenance for cutting system, spark plug, air filter, and oil.
Check blade condition before/after mowing. Replace worn/damaged blades. Sharpen annually.
Check spark plug after 5 hours, then every 25 hours. Clean deposits and check electrode gap.
Clean foam air filter in warm, soapy water. Squeeze dry and let air dry. Apply uniform layer of oil.
Check oil level between min/max marks. Change oil after 5 hours, then every 25 hours or annually.
Details model BBJ300, engine, displacement, power, tank capacity, oil capacity, cutting width, and dimensions.
Lists common problems like engine not starting, stopping, or vibrating, with likely causes and suggested remedies.
Domestic warranty for 1 year. Covers defective parts replaced by Authorised Dealer. Does not cover misuse or consumables.
To Next Page
