SANLI LBP350 User Manual (English)

Questions and Answers:

T
Tammy WilliamsAug 1, 2025
Why my SANLI LBP350 engine does not start?
- M
  Ms. Alexandra Horton MDAug 1, 2025
  If your SANLI Lawn Mower engine doesn't start, several factors could be at play. Make sure the throttle lever is correctly set to ‘Cold Start’ for a cold engine or slightly lower when warm. Check the fuel level and refill the tank with 95 octane regular unleaded petrol if it's low. Inspect the spark plug; it might be dirty or depleted, requiring cleaning or replacement. Ensure the spark plug cover is firmly connected. If the engine is flooded, turn the fuel ‘off,’ then zip until it starts, and then turn it back ‘on.’ Old petrol in the tank can also be a culprit, so drain and replace it with fresh unleaded fuel. If you suspect water in the fuel tank, contact an authorized Sanli dealer.
S
spencerdanielleAug 8, 2025
What to do if SANLI LBP350 Lawn Mower engine stops often?
- P
  Patrick NashAug 8, 2025
  If your SANLI Lawn Mower engine frequently stops, it could be due to a blocked fuel supply. Ensure the fuel line isn't pinched or blocked. The fuel cap might not be venting properly; try slightly loosening it. Also, using the wrong type of fuel can cause this issue, so drain the petrol tank and refill it with new unleaded fuel.
L
leahhancockAug 16, 2025
How to fix SANLI LBP350 Lawn Mower that vibrates too much?
- M
  Matthew JohnsonAug 16, 2025
  If your SANLI Lawn Mower is vibrating too much, several issues could be the cause. First, check the cutting blade to ensure it is not loose and tighten the bolt if necessary. A bent or broken blade can also cause excessive vibration, so replace the blade if needed. Lastly, excessive grass or dirt build-up can lead to vibration; clean the underside of the mower to remove any build-up.
J
Jesse RuizAug 25, 2025
Why SANLI LBP350 Lawn Mower engine loses power?
- P
  Philip FisherAug 25, 2025
  If your SANLI Lawn Mower engine loses power, it might be due to a dirty air cleaner filter. Clean or replace it with a new Sanli air-filter. Another potential cause is blocked fuel cap vent holes; ensure the three holes in the fuel tank cap are clear.