8 Sanli LawnBeetle User Guide
Before you begin.
WARNING! The following procedures must be carried out before you
start the engine of your mower.
1. Fill oil sump with oil.
The mower is NOT supplied with oil in the engine, however, a container with the
correct amount of oil (600ml) is supplied. It is essential that this is added before
starting the engine for the rst time.
Firstly, remove the warning label from under the dipstick, then remove the dipstick and
slowly pour the entire contents of the container into the engine via the oil ller. Replace the
dipstick and tighten.
Before you use the mower each time, check the oil level and if necessary top up with
SAE30 engine oil. To check the oil level, just unscrew the yellow dipstick, wipe with a
clean rag and replace into the oil ller, but do not screw it back in place, and remove
again. The oil level must be on or just below the MAX mark on the dip stick.
To Next Page
Loading...
