SANLI LBP350 - Initial Operation and Setup; Adjusting Cutting Height

Sanli LawnBeetle User Guide 7
Adjusting the Cutting Height.
WARNING! Turn mower off before adjusting cutting height lever.
Thelawnmowerhasthreecuttingheights.Itis
supplied with the height set in the middle position.
Sanli strongly recommends that you leave the
cutting height at the factory level as it encourages
a healthier lawn.
Eachofthewheelshavethreemountingholesas
showningure1.
The following procedure must be repeated for all
four wheels.
Use a thin blade to lever off the wheel cap,
see gure 2. Use the double ended box spanner
supplied to undo the wheel retaining bolt and
removethewheel,seegure3.
NOTE: The wheel bolts on the left side of the
lawnmower(whenviewedfrombehindthe
mower)haveareversethreadsothattheydonot
loosenduringnormaluse.Whenyouremovethe
wheel caps on the left side wheels you will see an
arrow on the bolt heads indicating the direction to
undo the bolts.
Replacethewheelretainingboltandwheelinthe
appropriate mounting hole for the desired cutting
height. The lowest mounting hole will give the
highest cutting height. The highest mounting hole
will give the lowest cutting height.
Replacethewheelcaps.
Figure1.
Figure 2.
Figure3.