Why my SANLI LS 40 engine does not start?
There are several reasons why your SANLI Lawn Mower engine might not be starting. It could be due to an incorrect throttle position (select the correct setting), a defective spark plug cap (replace the spark plug cap), an empty fuel tank (fill fuel tank), or a closed fuel flow valve (open the fuel valve). In case of ignition malfunction you should contact a SANLI approved dealer.
What to do if my SANLI LS 40 engine runs irregularly?
If your SANLI Lawn Mower engine is running irregularly, the issue might stem from a dirty air filter (clean or replace the air filter), a dirty spark plug (clean spark plug), or poor quality or contaminated petrol (drain the fuel tank and refill with unleaded 95 RON minimum).
How to fix a fall in engine power of SANLI LS 40 Lawn Mower?
A fall in engine power in your SANLI Lawn Mower could be due to a dirty air filter (clean or replace the air filter), a seized or blocked throttle control (clean the throttle assembly) or a lack of engine compression (in this case, contact a SANLI approved dealer).
Why is my SANLI LS 40 Lawn Mower vibrating so heavily?
Excessive vibrations in your SANLI Lawn Mower can be attributed to a few potential causes: loose screws or bolts (tighten the screws/bolts), a loose blade attachment bolt (check blade attachment bolt), or an unbalanced or damaged blade (replace blade).
What to do if SANLI LS 40 Lawn Mower engine becomes excessively hot?
If your SANLI Lawn Mower engine is overheating, check for blocked engine cooling fins and carefully clean the engine exterior. Also, verify the oil level, as a low oil level can cause the engine to overheat.
Why SANLI Lawn Mower has inadequate ejection of grass?
Inadequate ejection of grass from your SANLI Lawn Mower, resulting in clippings left on the surface, may occur if the engine speed is too low (increase throttle to max), the cutting height is too low (raise the cutting height), the blade is worn or bent (replace the blade), or there's a blockage between the deck and collector bag, or the bag itself is blocked (clear blockage/clean bag).
Why SANLI LS 40 Lawn Mower engine fires, but starting is difficult?
If your SANLI Lawn Mower engine fires but has trouble starting, make sure the operator control lever is fully pressed. Also, the engine oil might be too viscous for the current operating conditions, in which case you should change the oil.
How to avoid uneven finish with SANLI LS 40?
To avoid an uneven or poor finish with yellowing grass when using your SANLI Lawn Mower, ensure that the blade is sharp (sharpen or renew the blade), the cutting height isn't set too low (raise the cutting height), and the engine speed is sufficient (advance throttle to maximum).
Explains safety labels and symbols for safe mower use.
Essential checks and actions before operating the lawnmower.
Safety precautions and practices to follow during mower operation.
Necessary steps and considerations after completing mowing operations.
Steps and checks required to get the mower ready for operation.
Guidelines and procedures for operating the lawnmower safely and effectively.
Guide for cleaning, storing, and maintaining the mower.
General| Brand | SANLI |
|---|---|
| Model | LS 40 |
| Category | Lawn Mower |
| Language | English |
To Next Page
