SANLI LBP350 - Fuel Storage and Blade Inspection

12Sanli LawnBeetle User Guide
Oil changing.
Sanli recommends that the rst oil change is carried out after the rst 5 hours of mower
use. Thereafter, change the oil after every 25 hours of use or at least once a year. Also
check your oil level before mowing every time to ensure that the engine is being fully
protected. Sanli mowers run on SAE30 engine oil.
Using and storing petrol.
After three months, unleaded petrol begins to break
down and may make your lawnmower difcult to
start.Ifduringthecoldermonthsyouhavenot
mowed in a while, you should drain the remaining
fuel and replace with fresh unleaded.
Removethefuelcap,thenreleasethespringclip
on the black hose leading into the fuel lter and
then disconnect the hose ensuring you squeeze it
together rmly. Then release your grip on the hose
to allow the fuel to drain out into an appropriate
container.
Cutting blade.
Extremecareshouldbetakenwiththecuttingblade.Ensurethemowerisoffandthe
spark plug lead disconnected from the spark plug, to prevent accidental ignition.
Removethegrasscatcherandthenholduptherearapinordertoinspectthecutting
blade. Check every few months to make sure that it is not damaged, loose or worn.
Ifyouareplanningtochangethebladeyourself,usethickworkglovesandtakeextreme
care at all times. A full range of parts is available from your Authorised Sanli Dealer.