How to fix a SANLI LBP46 when the engine does not start?
If your SANLI Lawn Mower engine doesn't start, try these steps: first, ensure you've selected the correct setting. Next, replace the spark plug cap. After that, fill the fuel tank and open the fuel valve. If the issue persists, it's recommended to contact a SANLI approved dealer for further assistance.
Why is my SANLI LBP46 vibrating so much?
If you notice heavy vibrations from your SANLI Lawn Mower, try tightening the screws and bolts. Also, check the blade attachment bolt and replace the blade if necessary.
What to do if SANLI LBP46 engine runs irregularly?
If your SANLI Lawn Mower engine runs irregularly, you can try cleaning or replacing the air filter. Another solution is to clean the spark plug. You may also need to drain the fuel tank and refill it with unleaded 95 RON minimum.
Why is my SANLI LBP46 Lawn Mower engine getting too hot?
If your SANLI Lawn Mower engine becomes excessively hot, carefully clean the engine exterior. Also, check the oil level to ensure it is adequate.
Why is there a fall in engine power in my SANLI LBP46 Lawn Mower?
If you experience a fall in engine power in your SANLI Lawn Mower, you should clean or replace the air filter. Additionally, clean the throttle assembly. If the problem persists, consider contacting a SANLI approved dealer.
What to do if my SANLI LBP46 engine engages, but starting is difficult?
If your SANLI Lawn Mower engine engages, but starting is difficult, fully press the lever operator. You may also need to change the oil.
Why is the SANLI Lawn Mower transmission drive losing efficiency?
If your SANLI Lawn Mower's transmission drive operates but loses efficiency, adjust the cable using the tensioning device. If that doesn't resolve the issue, contact a SANLI approved dealer.
How to fix uneven cutting with my SANLI LBP46 Lawn Mower?
If you notice an uneven or poor finish with yellowing of the longer or lower grasses when using your SANLI Lawn Mower, sharpen or renew the blade. You might also need to raise the cutting height and advance the throttle to maximum.
What to do if my SANLI LBP46 Lawn Mower is not ejecting grass properly?
If your SANLI Lawn Mower has inadequate ejection of cut grass into the collector bag or excess grass clippings left on the surface, advance the throttle to maximum. Also, raise the cutting height, replace the blade if necessary, and clear any blockage or clean the bag.
Understand important safety symbols and their meanings for safe operation.
Pre-operation checks and preparations to ensure safe mowing.
Guidelines for safe operation while mowing.
Procedures for safe shutdown and post-mowing actions.
Steps for assembling and preparing the mower before starting work.
Instructions on how to start, move, and stop the lawnmower.
Guidance on cleaning, storing, transporting, and maintaining the mower.
General| Brand | SANLI |
|---|---|
| Model | LBP46 |
| Category | Lawn Mower |
| Language | English |
To Next Page
