EasyManua.ls Logo

SANLI LBP46 - Filling the Fuel Tank

SANLI LBP46
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 / User’s Manual Sanli LS42 - LSP42 - LSP46-LBP46
3.13 Filling the fuel tank
WARNING: Petrol is highly inflammable. Always handle fuel with extreme
care to avoid risk of burns, fire or explosion. The fuel tank should be filled
before starting the engine. Your mower’s engine runs on petrol alone - do not
add oil to the petrol.
Always use unleaded petrol of a minimum 95 RON. Buy only the quantity of
fuel that you plan to use in a month. Never transport and store petrol other
than in a container suitable for the purpose, approved and labelled
accordingly.
Always refuel outdoors, never in an enclosed space or near a naked
flame or heat source. Never smoke while filling the fuel tank.
Do not unscrew the tank cap when the engine is running or when the
mower is hot.
To add fuel, unscrew the fuel filler cap.
Slowly pour the fuel into the tank using the
fuel container’s spout (fig. 7) or a funnel.
The tank’s capacity is about 1 litre. Avoid
spillages by not overfilling the tank. Leave
about 13 mm space beneath the threaded
collar to allow for fuel expansion.
If fuel should overflow, do not start the engine. Move the mower away
from the place of spillage and carefully wipe down the mower. Any
attempt at starting should be avoided until petrol vapours have
completely gone.
Replace securely the caps on the fuel tank and the fuel container and
place the latter in a secure place away from heat or direct sunlight.
Before each mowing, visually inspect the condition of the mower’s fuel
tank and its cap, the fuel delivery pipe and the fuel filter.
If a fuel leak is seen or suspected, do not start the engine. Drain the fuel
tank using a fuel suction pump and immediately contact an approved
SANLI UK service dealer for advice.
NOTE: THE OIL FILLER CAP MUST BE SCREWED IN FULLY BEFORE STARTING
THE ENGINE. NEVER REMOVE THE FILLER CAP WITH THE ENGINE RUNNING.

Related product manuals