12 / User’s Manual Sanli LS42 - LSP42 - LSP46-LBP46
3.21 Starting the mower
Before starting the engine, please read thoroughly the instructions
regarding safe use of the mower (see pages 5 – 7).
Slide the throttle lever to and fro several times to ensure that it is
moving smoothly and correctly.
Check that the fuel tap is in the ON position (fig.9) and that the engine’s
oil level is correct (see paragraph 3.12).
Start the mower in a clear, level area. Do not start the engine if the
cutting blade is resting on rough and uncut grass as this may cause
difficulties at start-up.
For a cold start, move the throttle lever to the position marked:
For a hot start, move the lever to the position marked:
Stand behind the handlebars. Move the operator control lever
positioned in front of the handlebars rearwards so that the lever is
resting against the handlebars (fig.10). Take hold of the starter handle
firmly with the other hand.
Pull back the starter until you feel resistance and then pull the handle
firmly and briskly to turn the engine (fig.11).
Repeat the above procedure as necessary until the engine starts.
When starting from cold, gradually move the throttle lever to
the full throttle position (as shown right) after a few moments
of running.
3.22 Moving the mower
The LSP42, LSP46 & LBP46 mowers are equipped with a gearbox which allows
the mower to be self-propelled. When the transmission is activated, it
engages the rear wheels of the mower and the mower moves forward under
its own power.
To Next Page
Loading...
