PAGE 10
INSTRUCTION MANUAL
MAINTENANCE SCHEDULE
WARNING!
The following procedures must be carried out before you start the engine of your lawnmower.
!
SUMMARY OF REGULAR MAINTENANCE
REQUIRED BY THE MOWER
Before each
mowing
After 5 hours
Every 25 hours or once a year
minimum before winter lay-up
Cutting system
Check and verify
its condition
Sharpen and balance blade.
Replace worn or damaged blade.
Spark plug
Check
Clean and check the clearance
of the electrodes. Replace if
necessary.
Air Filter
Check
necessary.
Oil
Check the level
Drain and
renew
Drain and renew
OUT
IN
Frequency
Components
Cutting System
Before and after each mowing
session, check that the blade, its
attachment bolts and drive shaft
are not damaged or excessively
worn. Never try to straighten a
bent blade. Replace a damaged,
worn or bent blade as soon as
possible. Use only genuine SANLI
parts or those approved by SANLI.
Excessive vibration when mowing
is a good indication of a problem
with the cutting system.
Removing the blade
Wear appropriate protective
gloves to prevent possible
injury when handling the blade.
Disconnect the spark plug cap
and tilt the mower on its side with
uppermost.
hand, use a spanner or socket to
loosen the blade screw.
Sharpening the blade
For best mowing results, have the
edges sharpened and the blade
balanced at least once a year by a
specialist service dealer or agent.
Mounting the blade
Wear appropriate protective gloves
to prevent possible injury when
handling the blade. Disconnect
the spark plug cap and tilt the
uppermost.
Check that all components (the
blade, key, blade holder, screws and
washers) are present, clean and in
good condition.
Position the blade on its support
engine.
Check the correct alignment and
matching of pads with the blade.
The blade must be positioned
precisely on its stand.
Tighten the screws connecting all of
check that all parts are present and
(NB wear suitable gloves).
Spark Plug
Check the spark plug initially after
Thereafter, maintenance of the spark
plug should take place every 25 hours.
Remove the spark plug cap (Fig.14)
using a rotary motion and then remove
the spark plug with the wrench
provided (Fig.15).
Clean off any carbon deposits using a
copper brush and check the electrode
gap with a feeler gauge (the gap should
be ≈ 0.7 mm). Replace and tighten the
serviced spark plug and replace the
cap.
If the spark plug is worn or damaged,
replace with a new spark plug of the
same or suitable type for the engine.
We recommend to use NGK
BPR6ES or Torch F6RTC for Sanli
mowers.
If in doubt, contact your point of
purchase or local dealer.
WARNING!
!
Vibration from a bent or damaged
blade can cause costly damage to the
mower. Working with an excessively
worn blade wastes fuel and can
lead to injury if the blade becomes
detached from the machine.
Fig14
Fig15
To Next Page
Loading...
