6.3.9 HOLD FOR 9 SECS. ENTER TEST MODE
＊
This is for engineer usage only
Several test modes can be selected.
• Press the button for 4 seconds: test mode 0 – EEWS Test
• Press the button for 6 seconds: test mode 1 - on-site warning test level 3
• Press the button for 8 seconds: test mode 2- on-site warning test level 4
• Press the button for 3 seconds: test mode 3 – cancel
• Press 10 seconds to test all relays – intensity 1,3,5,7
6.3.10 HOLD FOR 10 SECS
No function.
6.3.11 HOLD FOR 11 SECS.
No function.
6.3.12 HOLD FOR 12 SECS TO SHUT DOWN.
＊ After selecting this option, the power must to be turned off to allow the system to be properly
restarted later
To Next Page