Need help?Do you have a question about the Sanlien Palert and is the answer not in the manual?
General| Brand | Sanlien |
|---|---|
| Model | Palert |
| Category | Security System |
| Language | English |
Details about the three main passwords for web interface and operating system access.
Procedure to connect a PC to the unit by changing IP address and network settings.
Instructions for logging into the unit via the web interface using default credentials.
Configuration of IP address, subnet mask, and gateway for external data transmission.
Steps to change the web interface password for the unit.
Configuring NTP servers for accurate time stamping of data.
Setting the Serial Number (S/N) and other unit information via the web interface.
Uploading and downloading configuration files and preloading settings.
Downloading CSV files containing movement details for specific events.
Viewing event files directly from the web interface, showing graphical data.
Checking live waveforms for all three axes of the unit.
Accessing and configuring system parameters, primarily for admin users.
Description of parameters related to early warning systems and local modes.
Details on additional configuration parameters not covered in early warning.
Configuration for 'N out of M' settings to reduce false alarms, specific to PX-01 and Cube.
Parameters for regional early warning, used by EEWS and shake map central systems.
Settings for voice alarms and event recording thresholds and durations.
Configuration details for MQTT messaging protocol for data sharing.
Procedures for putting the system into test mode for operational checks.
FTP configuration settings for unit firmware updates.
Default and alternative file formats for saving event data.
Settings related to controlling relay status and behavior.
API configuration parameters for system integration.
Configuration for uploading event records via FTP.
Configuration for UDP broadcast transmission port for event records.
Instructions for installing terminal access software like PuTTY.
Procedure to change the default user password via terminal access.
Description of the initial boot display on the PX-01 unit.
Information displayed on the unit's screen after successful boot.
Details functions triggered by holding the control button for different durations.
Mapping table for Analog Output (AO) Modbus registers.
Mapping table for Analog Input (AI) Modbus registers.
To Next Page