ATSC Converter Box
(J) Press "CH SCAN" to scan ATSC program channels.
rJa
S\ ~
Press "OK" to start Auto scan, It may take you several minutes.
Note:
• If you use F-Cable to connect the equipment and the TV, please set
"Audio Mode" to 'Mono" mode.
If you change the RF Channel to CH3 or CH4, you need to rescan.
(Please refer to your TV manual.)
• While you use RCA cable to connect to your TV. If your TV only have
one jack for audio in, you can set "Audio Mode" to "Mono" mode.
Unless set "Audio Mode" to "Stereo" mode .
• To Select the Time zone, use "CH+/CH-" to focus "Time Zone",
then use" ~ / ~ "to select the zone where you are located: Alaska,
Haweii, Pacific, Mountain, Central, Eastern.
l
- 09 -
To Next Page
Loading...