Sansui EIGHT User Manual

Displays FM and AM frequencies when the selector is set to the respective mode.

Turns the system on/off and controls power to AC outlets on the rear panel.

Allows selection between three pairs of connected stereo speaker systems.

Adjusts and visually indicates the balance between left and right audio channels.

Adjusts bass, midrange, and treble frequencies for desired audio response.

Controls high-frequency noise, low-frequency rumble, and interstation tuning noise.

Instructions for connecting the primary set of stereo speakers to SYSTEM-A terminals.

Guidance for connecting SYSTEM-B and SYSTEM-C speaker pairs.

Method for connecting a single speaker for temporary use via SYSTEM-C.

Details on connecting folded dipole or outdoor antennas for optimal FM reception.

Information on using the built-in ferrite bar or outdoor antennas for AM reception.

Steps for selecting FM stations using the tuning knob and meters.

Instructions for connecting two record players or pickup arms to PHONO inputs.

Steps for selecting sources, adjusting controls, and playing records.

Guidance on preventing hum and howl caused by improper connections or placement.

Details on connecting tape decks via DIN, pin-jack, or microphone connectors.

Procedures for recording from various sources using one or two tape decks.

Steps for playing back tape recordings and monitoring through the amplifier.

Highlights benefits like independent amplifier use and superior filter characteristics.

Explains how to integrate the EIGHT with an electronic crossover unit and power amplifiers.

Methods for reducing AM and FM reception noise from various sources.

Procedure for adjusting the muting level to suppress background noise.

Guidance on identifying and replacing blown fuses, including quick-acting and power fuses.

Details on the switched and unswitched AC outlets, including capacity limits.

Instructions for proper grounding to improve SN ratio and system stability.

Guide to adjusting the voltage selector for different power supply regions.

Specifies fuse changes needed based on the selected operating voltage.

Detailed technical data for music power, THD, IM distortion, and bandwidth.

Information on output voltage, sensitivity, impedance, and damping factor.

Technical data for FM/AM tuning range, sensitivity, selectivity, and separation.