Sanus BMT1 - Page 24

24
4. Place wall plate template
06
at your desired height and position over your stud center line(s). Level wall plate template
06
and tape in place.
CAUTION: Avoid potential personal injury or property damage! SINGLE STUD installs MUST use the center holes in the stud as shown.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT: Be sure you mark and drill into the center of the stud.
5. Drill the four pilot holes using a 1/2 in. (13 mm) diameter drill bit in the locations illustrated for double stud or single stud installs.
IMPORTANT: Pilot holes must be drilled to a depth of 1 in. (25 mm).
4
STUD
STUD
STUD
STUD
STUD
STUD
DRYWALL
DRYWALL
5
1 in. (25 mm)
1/2 in.
(13 mm)
06 06
06 06
DOUBLE STUD DOUBLE STUD
SINGLE STUD SINGLE STUD