Sanus BMT1 - Page 25

25
6
8
7
9
07
C
C
10
6. Remove template
06
and insert the four anchors
S1
*
into the drilled holes (DOUBLE STUD installs = four in studs. SINGLE STUD installs =
two in studs / two in dryway).
7. Pull to rotate the anchor
S1
*
inside the wall.
8. Hold the end of the anchor
S1
*
, while sliding the cap
P
against the drywall.
9. Snap off the ends of the anchor
S1
*
to lock in place.
CAUTION: Be sure the cap
P
is seated against the drywall surface and the ends of the anchor do not extend beyond the cap
P
- cut if neccessary.
10. Slide the covers
C
open on the wall plate
07
to expose the mounting holes.
S1
S1
S1
S1
P
P