Sanyo CDP-150 - Page 19

Changing the Last Portion of a Program
Example: Change the programming from pro-
gram 4 onward
i.
2.
3.
4.
5.
Press the SET button to display track num-
ber 1 (program number 4).
TRACK NO.
Deleting the Program
[
/-/
1
/_/ /
❑
1
2.
1. Press the SET button to select
5 (Wogram number 1).
TRACK NO.
/
Press the F BACKor F FWD button to set the
track number display to “00”.
TRACK NO.
1
/-//-/
/_//_/
❑
1
Press the SET button to delete program 4
and the following programs. The display will
indicate track number 5 (program number
1).
TRACK NO.
I
l–l /:
/_/ _/
❑
I
Press the SET button to display “00”.
Program subsequent entries using the fol-
lowing procedure: press the F BACK or F
FWD button to display the track number,
then press the SET button.
[
/-/
1’
/_/ _/
❑
rack number
I
Press the F BACK or F FWD button to set the
track number display to “00”.
TRACK NO.
[
/-/
~-l
/_/ /_/
pJ
1
3.
Press the SET button and the entire pro-
gram will be deleted.
The programs will be lost in the following
circumstances.
. When the disc compartment is opened.
● When the rechargeable nickel-cadmium
battery or the alkaline batteries are ex-
hausted.
. When the rechargeable nickel-cadmium
battery or the alkaline batteries have not
been installed and the AC adaptor is discon-
nected.
Normal play without erasing the program
1. Press the P.MODE button during pro-
grammed play. When the”
❑ “ display goes
out, normal play resumes.
2. To return to programmed play, press the
P.MODE button to display “~”, then press
the -/11 button.
-19-