● Preferred language.
1. Press the MENU button to select Main Menu.
2. Select Configuration by using the
e
or
d
buttons. Press the OK
button to enter.
3. Press the
d
button to highlight Preferred language and press
the OK button to enter.
Audio - Select your preferences as required.
Example. If you speak Welsh or Gaelic and prefer to receive
Welsh or Gaelic audio when it is transmitted then select Welsh or
Gaelic for your first Language and English as your second.
4. Press the
7
or
8
button to select Language, press the
e
or
d
buttons, select second language and change your preference
using the
7
or
8
buttons.
Subtitling - Select your preferences as required.
If you wish for Welsh or Gaelic Subtitles instead of English to be
shown (when available) then select your preference for the first
language.
Example: as shown will give you English first language, if not
available Welsh may be shown.
5. To change press the
e
or
d
buttons to highlight the box and
press the
7
or
8
buttons to select your preferred First language
and repeat for Second language.
6. Press the
d
button to select Subtitle display. This can be set ON
or OFF by pressing the
7
or
8
buttons.
7. Press the OK button to Save.
The above display bar will appear on the screen as it is returned to
the normal TV picture.
● Common Interface
This TV set provides a common Interface slot on the top rear of the
TV set behind the control buttons. .
1. Press the MENU button to select Main Menu.
2. Select Configuration by using the
e
or
d
buttons. Press the OK
button to enter.
3. Press the
d
button to highlight Common Interface and press the
OK button to enter.
The following screen appears to show that a card is inserted.
When you select OK, follow the on screen directions. This will vary
depending on the type of card inserted.
Important!
The TV should be turned off by the Mains Power switch when insert-
ing or removing the Common Interface Card, otherwise it may cause
damage to the card or the TV set.
● Preferred Setup
1. Press the MENU button to select Main Menu.
2. Select Configuration by using the
e
or
d
buttons. Press the OK
button to enter.
3. Press the
d
button to highlight Preferred Setup and press the
OK button to enter.
4. Press OK on the remote to Select MHEG5 for Digital Teletext or
Select Subtitles for on screen subtitles by using the
e
or
d
but
tons.
5. Select OK to save your preferred setting and exit the menu. On
exiting the menu screen a message appears showing that the set
tings chosen have been activated.
6. The message on screen for Subtitles will read Priority set to DVB
setup
Configuration
To Next Page
Loading...
