24
PC OPERATION
Connect your PC to the connector on the left side terminal of the
set. Once connected select PC mode via the v button on your
remote control. The set will become a monitor for the PC.
By pressing the MENU button on the remote control a menu window
will appear on screen, this allows the settings to be adjusted.
Press the 8 button to enter Sound menu. This will adjust Volume/
Balance/ Bass/ Treble/ Preset and Surround sound. The display is
the same as TV mode (page 8/16)
To adjust the Picture settings select picture using the e or d buttons
on the remote then the 8 button to enter the following picture
settings menu.
Press the 7 or 8 buttons to adjust the Picture bightness and the
same to adjust the contrast of the picture.
Picture position changes the picture horizontally or vertically, this is
done by using the 7 or 8 buttons on the remote control.
Video adjust changes the Phase and the clock of the screen. If the
picture is blurred or grainy this function will adjust it to a clearer
picture.
Auto Adjust will automatically adjust the picture by using the 8
button. This will change all the above settings automatically .Auto
adjust can also be acheived by pressing the
button on the remote control
Resolution displays the current resolution of the picture. This is just
for information and cannot be adjusted.
Using the 7 or 8 buttons it is possible to adjust the tone of the
screen using the White tone Red(R) / Green (G)/ Blue(B). This will
adjust the picture to show more of the choosen colour for example if
red is selected you can adjust the red in the picture to increase or
decrease using the 7 or 8 buttons
To select the Settings menu press the menu button on your remote
and using the e or d buttons to select Settings. The 8 button will
enter the settings menu.
Child lock/ Timer and AV2 settings are the same as in the TV mode
(pg 16/17)
Power save if turned ON will turn the TV to stand by after 1 minute if
no signal is detected, the LED light will turn RED to indicate stand
by. The TV will automatically turn on when a signal has been
detected. Use 7 or 8 buttons to selected ON or OFF.
PC menu settings
To Next Page
Loading...
