Sanyo DC-C30 - MAINTENANCE; Cleaning Tape Heads and Mechanism; Cleaning the Unit Exterior; Using the sleep timer

To release the timer
After turning the power on, press the TIMER button, then press the ■ (or
SET/CLEAR) button.
When using the main unit, use the ■ button (CD section).
When using the remote control, use the SET/CLEAR button.
1
To set the timer again with the same settings
1, Press the TIMER button, then press the ■ (or SET/CLEAR) button.
2. Press the o/ON button to switch off the power.
Note:
If the ■ (or SET/CLEAR) button is pressed while the timer is being set,
the original display returns.
- The timer mode is released if a power failure occurs during timer
controlled operation.
The timer may not operate if a power failure occurs during timer
operation standby mode.
Using the Slt3ef) timer (Using the remote control)
The sleep timer automatically switches off the power after a preset time
has elapsed. The volume will gradually be reduced (fade-out) during the
1-minute period before the unit turns off. There are 12 time periods
available: 120, 110, 100, 90, 80, 70, 60, 50, 40, 30, 20, and 10 minutes.
Press the SLEEP button repeatedly to select the desired sleep time.
“SLEEP and the selected time blink on the display. After several seconds,
the original display returns. “SLEEP blinks.
To check the remaining sleep time
Press the SLEEP button once. The remaining time is displayed. After
several seconds, the original display returns.
To release the sleep timer while in operation
Press the SLEEP button, then press the SET/CLEAR button. The timer is
also released if the power is switched off.
Cleaning the tape heads
B
To ensure continued high performance, use cotton swab to clean the
heads, pinch rollers and capstans of the decks after about every 10 hours
[6
l—
of use. If the dirt persists, soak the swab in a little methylated spirit or head
cleaning fluid and then clean.
Cleaning the unit
#
Clean the outside of the unit with a clean soft cloth, moistened with
87
lukewarm water, Do not use benzene, thinner or alcohol since they will mar
the finish of the surfaces,
m
/72
l—
*
1.
2, 6.
3, 7.
4, 5, 8.
543
Cotton swab
Capstan
Pinch roller
Head
(AU) 1AD6P1 P0882-F
SANYO Electric Co., Ltd.
-11-
Printed in China