Sanyo DC-D8 - Tape Dubbing; Maintenance

1.
2.
3.
4.
5.
TAPE DUBBING
Load the playback cassette into deck A and a blank cassette into
deck B.
Set the FUNCTION switch to TAPE.
Setthecassettein deck Atothe point where recording will begin.
Select the dubbing speed with the DUBBING/BEAT CANCEL
button.
NOR:
For dubbing while monitoring at normal speed.
HIGH:
For dubbing the tape at high speed (twice normal speed).
Press the PAUSE button on deck B.
(DECK A to DECK B)
6. Press the REC button on deck B.
7. Press the PLAY button on deck A to start dubbing.
8. To stop dubbing, press both STOP/EJECT buttons.
Automatic stop during dubbing
If deck B stops automatically, deck A continues playback mode at
normal speed.
If deck A stops automatically, deck B erases the tape to the end.
Do not change the dubbing speed during the dubbing operation.
MAINTENANCE
Cleaning the decks A and B heads
DECK B
To ensur~ playback and recording with good-quality sound, use
cotton swab to clean the heads, pinch rollers and capstans of the
decks after about every 10 hours of use.
If the dirt persists, soak the swab in a little methylated spirit or head
cleaning fluid and then clean.
Main unit
Use a soft cloth to remove dirt on the main unit.
If the dirt persists, dip a soft cloth into a diluted solution of neutral
detergent, wring it out, wipe away the dirt, and then take up any
moisture with a dry cloth.
Do notusebenzene, thinners or alcohol since they will marthefinish
of the surfaces.
II *
l—
4
‘ii
543
DECK A
II ~
l—
4
87
1,
Cotton swab
2, 6.
Capstan
3, 7. Pinch roller
4, 8.
Record/Play head (Play head in DECK A)
5.
Erase head in DECK B
-1o-