Need help?Do you have a question about the Sanyo DC-DA2000 and is the answer not in the manual?
Tuner| FM frequency range | 87.5 - 108 MHz |
|---|---|
| AM frequency range (9 kHz step) | 522 - 1710 kHz |
| AM frequency range (10 kHz step) | 520 - 1710 kHz |
CD Player| Channels | 2-channel stereo |
|---|---|
| Sampling frequency | 44.1 kHz |
| Laser output | 0.6 mW |
| Wave length | 790 nm |
Cassette Deck| Track system | 4-track, 2-channel stereo |
|---|---|
| Frequency response | 80 Hz to 15 kHz |
| Signal-to-noise ratio | 40 dB |
| Wow/flutter | 0.15% (WRMS) |
| Fast forward/rewind time | Approx. 110 sec. (C-60) |
General| Output power | 4W x 2 |
|---|---|
| Power requirements | AC 230 ~ 240 V, 50 Hz |
| Power consumption | 21 W |
| Dimensions | 150(W) x 230(H) x 205(D) mm |
| Weight | 2.3 kg |
Speaker Systems| Type | Full range bass reflex |
|---|---|
| Unit used | 10 cm cone type |
| Maximum power-handling capacity | 8 W (peak) |
| Nominal impedance | 4 ohms |
| Dimensions | 145(W) x 230(H) x 170(D) mm |
| Weight | 1.2 kg (per speaker) |
Warns about invisible laser radiation when open and interlocks defeated. Avoid beam exposure.
Warns that improper controls/procedures may result in hazardous radiation exposure.
Instructions on how to connect the left and right speaker leads to the respective sockets.
Guidance on positioning the FM indoor aerial for optimal reception with minimal distortion and noise.
Lists and describes general controls like Standby indicator, Display, Remote sensor, Function, Bass, Sound Preset, Surround, Headphones, Volume, and Power buttons.
Details controls for CD playback (Repeat, Play/Pause, Stop, Skip) and tuner operations (Band select, Preset tuning).
Lists controls for cassette playback (Play, Stop, Fast Forward, Rewind, Record, Record Pause).
Explains the function of each button on the remote control, including number buttons, volume, memory, CD/Tuner controls, and cassette controls.
Instructions on how to insert batteries into the remote control and a note about removing them if not in use.
Specifies the effective range and angle of the remote control's operation.
Details how to turn the unit on and off using the power button and the standby mode.
Explains how to select functions like CD, Tape, or Tuner using the FUNCTION button.
Describes how to adjust the volume using the unit's control or the remote control.
Explains the function of the SURROUND button to create a 3D sound effect.
Describes the function of the BASS button to enhance bass sound.
Guides on selecting sound modes like POP, ROCK, JAZZ, CLASSIC for music listening.
Provides a step-by-step procedure for resetting the unit if operations become abnormal.
Explains how to search for specific points within a track during playback.
Describes how to repeat playback of all tracks or programmed tracks and how to cancel it.
Details how to program up to 24 tracks for custom playback order.
Provides important notes on handling and cleaning compact discs to prevent damage.
How to select and start playback from a specific track using the unit or remote.
Explains how to pause playback and resume it later.
Describes how to skip to a specific track number or between tracks.
How to view programmed track details on the display using the remote.
Instructions on how to add or change tracks in a programmed playback sequence.
Information on setting the AM frequency band according to local broadcast systems.
Explains how to tune into radio stations using automatic or manual methods.
Guides on manually and automatically presetting radio stations for quick access.
How to select and listen to previously preset radio stations.
Describes how to scan through preset stations, stopping at each for a few seconds.
How to ensure FM stereo reception and switch to mono if needed for better signal quality.
Provides steps to mitigate high-pitched noise (beat interference) during radio reception.
Instructions on how to fast forward or rewind a cassette tape.
How to select the "LINE" function to listen to external audio sources like video equipment.
Step-by-step guide for recording audio from a CD to a cassette tape synchronously.
Instructions on how to record audio from the radio tuner or other connected sources.
How to address high-pitched noise during radio recording using specific settings.
How to create blank spaces during recording to omit unwanted program parts.
Explains how to prevent accidental erasure of cassette tapes by breaking out tabs.
Guidance on cleaning the tape heads, pinch roller, and capstan for optimal performance.
Instructions on how to clean the CD player lens using a blower, avoiding touching it.
How to clean the exterior of the unit using a soft, moistened cloth.
Lists reception frequencies for FM and AM bands.
Details channels, sampling frequency, pick-up type, laser output, wave length, and wow/flutter.
Specifies track system, frequency response, SNR, wow/flutter, and fast forward/rewind time.
Includes output power, outputs, power requirements, consumption, dimensions, and weight.
Details speaker type, unit used, max power handling, impedance, dimensions, and weight.
To Next Page
